INSTRUCTION SHEET TO BRING TO AUDIOLOGIST
Please use a slim otoblock. If you do not have a slim otoblock then carefully tear the full one in half and tie the string in a knot.
You must use silicone impression material. Powder and liquid impressions will not be approved for manufacturing.
You must take an open mouth impression. A bite block is preferred. However, if you do not have a bite block then have the patient wrap two fingers in paper towel and stick them vertically between their two front teeth. This will keep them from closing their mouth.
Fill the entire canal canal, and overfill the concha and helix area.
Press on the impression material immediately after taking the impression. I know you were probably taught not to do that but with these molds you must press down the material.
Impressions must be:
Past the second bend
Overfilled to
show depth especially in concha area
Have full helix/anti helix
Impression material must touch otoblock

图挂了，直接复制了

自顶

没人帮我吗

学渣帮顶

就是你一定要用silicone材料的耳模，而且要做耳模的时候一定要张口，13&16用户帮顶

最好找一家有经验的做 像耳科诊所之类 因为你告诉他耳机型号 人家就知道做什么样的耳模

2个月

不是吧，这是说明书啊，而且也没说要我做耳印寄给他们

耳膜做失败了，被人坑了

把听力教学片
请用一个苗条的otoblock。如果你没有一个苗条的otoblock然后小心撕满的一半，把线打个结。
你必须用硅胶材质。粉末和液体的印象将不被批准用于制造。
你必须接受一个开放的口腔印象。咬块是首选。但是，如果你没有一个咬块，然后有病人用纸巾包纸包，并坚持他们的前牙垂直。这将使他们从关闭他们的嘴。
填满整个管道，和过量甲和螺旋区。
在给人印象深刻的印象后立即按。我知道你可能被教导不要做这些，但与这些模具你必须按下的材料。
印象必须：
过弯
溢出到
显示深度特别是甲区
有全螺旋/反螺旋
印模材料必须接触otoblock